Home Technical Information Resistance Thermometers 4. Sensor resistances on ceramic carrier

Technical Information

4. Sensor resistances on ceramic carrier

Temperature range of 70°C to +500°C. Special types from-196 °C to +500°C.

The platinum coating which is relevant for the temperature measurement is applied respectively according to one of the three following procedures:

  • Screen printing
  • evaporation
  • sputtering.

With all three procedures the structuring of the resistance with the laser can take place.

In the first procedure the resistance can be also printed directly. In thin-film technology today structuring the resistance as from semiconductor technology known through optical lithography and sputtering cauterisation is accomplished.

The fine adjustment always takes place with a laser. For this with the production of so-called trim or adjustment straining of different length (and thus different resistance) in is produced in the meander which is now activated depending on need by interruption of the prime conductor strip.

Ill.  Sheath sensor resistance

Ill. Sheath sensor resistance

Ill.: Structure layer sensor resistance

Ill.: Structure layer sensor resistance

The meander surface is covered with melted glass. These resistances are oscillation resistant under normal installation conditions.

The hysteresis of these resistances behaves approximately the same as with the glass types. Sheath sensor resistances are only a few millimetres in size , are the most economical of all sensor resistances and yield very good measurement results.

Consultation about your temperature measurements? We'll call you back.

preferred day / time
send

Choose your language

Langkamp-Technology-ISO-9001
Accredited work placement company

DIRECT CONTACT WITH OUR TEAM

Langkamp Technology B.V.
22 Molenvliet
3961 MV Wijk bij Duurstede
Netherlands

Phone: +31 (0)343-595410
info@ltbv.nl